Capital Products: Wet Screens
Inclined Circular Motion Dewatering Screens (ICMDS)
The ICMDS is the latest release in the Minspec range of inclined screens , features include ease of installation and maintenance.
General specification
Mechanism
The screen is excited by twin circular motion Uras out of balance motors bolted directly to the side plates. This feature eliminates the need for a torque tube, eccentric shaft, bearing assemblies and motor v belt drive.
This type of arrangement is easier to maintain due to the elimination of daily greasing of bearings and labyrinths.
Side plates
The side plates are grade 250 steel stress relieved and c/w drip angles, stiffeners and spring brackets.
Deck frames
The deck frame cross members are made from hollow section, after fabrication and weld testing the deck frame is stress relieved.
Screen cloths
Will be cross tensioned either in woven wire or polyurethane to the customers requirements.
Feed box
The feed box will be lined with bolt on liners extended to overlap first panel to ensure no spillage down back of panels.
Discharge lip
The discharge lip is protected by Minspec 40 rubber liners.
Isolation
Four point isolation is by means of plastic coated steel coil springs c/w base plates
MINSPEC ICMDS = LIGHTER SCREEN = LESS FORCE = LESS MAINTENANCE
Horizontal Linear Motion Dewatering Screens (HLMDS)
The HLMDS is the Minspec range of horizontal screens , features include ease of installation and maintenance.
General specification
Vibrating mechanisms
The screens are excited by twin under and over Uras out of balance motors for ease of installation and maintenance
This type of arrangement is easier to maintain due to the elimination of daily greasing of bearings and labyrinths.
Mechanism drive beam
This is of circular construction complete with large end flanges for even dissipation of forces through the side plate. After fabrication and weld testing the beams are stress relieved, end plates and exciter pads are machined and precision drilled to facilitate fitment between sideplates and accommodate the exciters.
Side plates
The side plates are grade 250 steel stress relieved and c/w drip angles, stiffeners and spring brackets.
Deck frames
The deck frame cross members are made from hollow section, after fabrication and weld testing the deck frame is stress relieved.
Screen cloths
Will be modular polyurethane or wedgewire to the customers requirements.
Feed box
The feed box will be lined with bolt on liners extended to overlap first panel to ensure no spillage down back of panels.
Discharge lip
The discharge lip is a blank polyurethane panel with drip ledge to prevent spillage into the undersize chute
Isolation
Four point isolation is by means of plastic coated steel coil springs c/w base plates
MINSPEC HLMDS = LESS MAINTENANCE
Inclined Circular Motion 2.4 x 4.8 |
|
Horizontal Liner Motion 1.2 x 2.4 |
|
